AJA Ki PRO rack Spezifikationen PDF herunterladen (Seite 61)

Ki Pro Rack Installation and Operation Manual — CONFIG menus

32.0 Loss of Video

This parameter selects whether recording continues when valid video is not present.

Note: If CONT Rec is selected, and a loss of video is encountered, a graphic with the text “LOSS

OF VIDEO” superimposed over color bars will appear. Be sure to check your source and

video connections if you are experiencing a loss of video.

35.2 REMOTE CONTROL

Enables or disables Ki Pro remote control by an external device. With the RS422

selection, an external RS422 controller or an NLE may be used to control the Ki Pro.

With the FW selection, an HDV camcorder’s start/stop commands and timecode can be

transmitted to the Ki Pro.

The CONFIG menu parameter 8.0 TC IN is set automatically to correspond to the RS422

Only. When the 8.0 TC IN is set to RS422, it allows Ki Pro to accept an RS422 in-point

timecode value as the beginning timecode value for the recording. Example: the value

01:00:00:00 is received as the in-point; this becomes the first frame of the Ki Pro

recording.

IMPORTANT: Ki Pro can be used as a player or a recorder under RS422 operation, but

when used as a recorder, Ki Pro can only perform assemble edits, not insert edits. This

means that Ki Pro creates a new file for each assemble edit performed; Ki Pro cannot

insert into an existing file.

Ki Pro can operate on a solitary clip under remote control or all of the clips on the

Storage Module. Whether one clip or all clips are active under RS422 is determined by

the MEDIA menu parameter 15.1 Play Media. IMPORTANT: Ki Pro may react erratically if

invalid clips or media are present and 15.1 Play Media "All" is selected.

Note: Ki Pro RS422 device control under a single clip is designed so that the clip may be

obtained in its entirety via non-linear capture. This is made possible because Ki Pro

produces video black/silence prior to the first frame of video for the single clip and after the

last frame of video for the single clip. This means that unlike videotape where you might

not have sufficient pre-roll to ingest a take into a non-linear editor, Ki Pro allows you to

obtain the whole clip by marking the in-point for ingest as the very first frame of video

recorded.

32.0 Loss of Video STOP Rec(default)

CONT Rec

Recording stops when video is lost

Recording continues when video is lost

35.2 REMOTE CONTROL Local Only (default)

RS422 Only

Selects Ki Pro control via front panel or web UI

Selects RS422 control of Ki Pro

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 112 113

Keine Kommentare

AJA Ki PRO rack Spezifikationen Seite 61